Challenge

V-Belts for industrial use are designated both to RMA standard Z18-CHALL where the letter designates its cross-section and the number corresponds to a nominal internal length in inches and to DIN standard 10x457Li, where the first number denotes the width in mm, and the second number is the internal length in mm. If you require …

Challenge Z18-1/2-CHALL Classical V Belts can be used on all types of industrial equipment. With an inside length of 18.5 inches (469.9mm) and a Z section, these Classic Classical V Belts have specially treated jackets to give superior anti-static, heat and oil-resistant properties and are static conductive to ISO1813.. If you require additional information please …

Challenge Imperial Timing Belts for industrial use where Part numbers are identified by a 3 or 4 digit number (e.g. 10 inches ) which represents the pitch length, 1 or 2 letters which signify the belts pitch (e.g. 0.2″) and a 2 or 3 digit number (e.g. 3/8″) the belts width giving the part number …

Challenge Imperial Timing Belts for industrial use where Part numbers are identified by a 3 or 4 digit number (e.g. 15 inches ) which represents the pitch length, 1 or 2 letters which signify the belts pitch (e.g. 0.2″) and a 2 or 3 digit number (e.g. 1/4″) the belts width giving the part number …

This 11 teeth 3/8″ sprocket with a Pilot Bore of 10 mm is manufactured by Challenge in C45 steel. . This Duplex sprocket fits chain 3/8” x 7/32” and has a part number 3DR11 and is available from stock. If you require additional information please contact Sales on 01952 676926.